Blend and propel 2-part polymers with the U.S. Saws Electric Dual Component Polyurea Gear Pump!
The easiest to use and maintain pump on the market. This pump was designed to be easy to use and inexpensive to maintain.
6 gallon tanks allow you to add a full 5 gallons of joint fill material and still have a reserve. Semi-transparent tanks allow the operator to monitor the level of liquid in the tanks.
Easy to clean as the full size tank lids provide unrestricted access to the inside of the tanks.
Available power with a deep cycle battery and power inverter for "cordless convenience"
Pumps are driven by a single chain to ensure consistent pump ratio.
Strong enough to pump polyurea or epoxy joint fillers
*Will also dispense certain polyaspartic floor coatings
Specifications:
- Weighs 170 lbs
- Volume Control Knob
- 1-1/4¼ " Steel Tube Frame
- Easy clean polyethylene tanks
- Clean and efficient Catalytic Muffler
- ½ Horsepower 110 Volt Electric Motor
- Pump 4,000 – 7,000 lineal feet per day
- Aluminum mixing Manifold with Flow Control
- Flexible pad driver follows contours of uneven floors
- 0-.6 GPM Variable Speed Flow Control on Dispensing Wand
- Weight:
- 170 lbs
- Motor:
- 1/2 HP 110V electric
- Pump:
- 4,000 - 7,000 lineal feet per day
- Variable Speed Flow Control:
- 0 - .6 GPM
- Technical Data:
- Download Here
- Operating Manual:
- Download Here
