Armor-Hard Extreme Concrete Repair
Fast Setting Epoxy for Repairing Cracks and other Surface Defects
ARMOR-HARD EXTREME 1 gallon Epoxy Liquid will repair your concrete floor for industrial-type traffic!
This EXTREME epoxy is meant to withstand the beating of industrial equipment and constant pounding. It is composed of two-component, 100% solids epoxy system designed for ambient to cool temperature applications.
As a mortar; Large spall repair/rebuilding of joint shoulders, As a topping for de-laminated slabs, Fill in holes, potholes, gouges, ruts, pop-outs. As a liquid; Fill wider random cracks.
Limitations: Should not be used in active or moving joints unless a relief joint is formed or saw cut, For deep repairs at warm temps. install in maximum 1" layers to avoid shrinkage due to exotherm, Should be installed at 20°F (-7°C) or higher.
Advantages: Quick set allows for: Foot traffic in 1 hour; normal traffic in 2 hours, Superior wear and impact resistance, Wider application range than most structural epoxies, from +120°F (49°C) down to 20°F (-7°C), Low odor; 100% solids, USDA/FDA/LEED acceptable.
Color: Epoxy liquid color is a translucent/clear. If blended with aggregate mortar color will become aggregate color.
Confused about the ARMOR-HARD Products? There is ARMOR-HARD and ARMOR-HARD EXTREME. Both come in 1 gallon or the Kit with Aggregate. ARMOR-HARD is faster than standard structural epoxies, but slower than EXTREME.
Armor-Hard must be shipped freight due to contents
Composition
Armor-Hard Extreme is a 100% solids, two component fast set structural epoxy/epoxy mortar kit intended for use in the structural repair or joints, cracks and other surface defects in industrial concrete floors. Armor-Hard Extreme’s fast set chemistry allows for return to service in as little as 2 hours and allows for installation in temperatures as low as 20ºF (-7ºC). Kit includes a specially engineered aggregate blend designed for easy troweling/finishing.
Compressive Strength: 12,800 psi
LEED Compliant: Yes
Packaging:
1 Gallon Liquid Only Kit
Related Products
ARMOR-HARD is available in two primary versions: ARMOR-HARD EXTREME Liquid or Kit - Quick set properties, multiple temperature applications. ARMOR-HARD Liquid or Kit - Early Set properties (faster than standard structural epoxies, slower than EXTREME), use limited to temperatures of 50˚F +.
Typical Use
- As a mortar
- Large spall repair/rebuilding of joint shoulders
- As a topping for delaminated slabs
- Fill in holes, potholes, gouges, ruts, popouts
- As a liquid
- Fill wider random cracks
- Technical Data:
- Download Here
- SDS:
- Download Here
- Color Sheet:
- Download Here
- Joint Rebuild Sequence:
- Download Here
