Armor-Hard Epoxy Liquid 1 Gallon -Metzger/ McGuire

Armor-Hard Concrete Repair Epoxy

Concrete Floor Repair for Joints, Cracks, and Surface Defects

ARMOR-HARD 1 gallon is a two-component, 100% solids epoxy system with early set properties.

ARMOR-HARD was developed specifically for the repair of industrial concrete floors subject to hard-wheeled traffic. ARMORHARD's primary use is in combination with sand aggregate to create a trowel-able mortar. It can also be used in its liquid form for certain repairs. 

Color of the blended epoxy is translucent/clear, but mortar color will be the color of the aggregate used. Typical Use: As a mortar; Spall repair/rebuilding of joint shoulders, As a topping for delaminated slabs, Fill in holes, gouges, ruts, and popouts.

Repair broken slab panel corners; As a liquid; Fill wider random cracks. Bond concrete to concrete. Limitations: Should not be used in joints or cracks that move. For deep repairs install in max. 1" (25 mm) deep layers to avoid shrinkage due to exotherm. Not for use as a surface coating. Should be installed at 50°(10° C or higher.

Advantages

• Early set allows for Pedestrian/ Construction traffic in 3-4 hours
• Grinding/Sanding in 3-4 hours,
• Hard-wheeled traffic in 8 hrs. or less (at 70° Requires no separate primer, USDA/FDA acceptable, superior impact, abrasion, and chemical resistance)

Confused about the ARMOR-HARD Products? There is ARMOR-HARD and ARMOR-HARD EXTREME. Both come in 1 gallon or the Kit with Aggregate. ARMOR-HARD is faster than standard structural epoxies, but slower than EXTREME.

Armor-Hard must be shipped freight due to contents

Composition

Armor-Hard is a 100% solids, two component structural epoxy mortar kit intended for use in the structural repair or joints, cracks and other surface defects in industrial concrete floors. Armor-Hard Kit comes with a specially engineered aggregate blend designed for easy troweling/finishing.

Compressive Strength: 10,500 psi

LEED Compliant: Yes, Download the LEED Compliance Letter  

Packaging:

1 Gallon Liquid Only Kit
Bulk Kit with Blended Aggregates (540 ci mortar yield)

Related Products/Versions

ARMOR-HARD is available in two primary versions: ARMOR-HARD Liquid or Kit - Early Set properties (faster than standard structural epoxies, slower than EXTREME), use limited to temperatures of 50˚F +. ARMOR-HARD EXTREME Liquid or Kit - Quick set properties, multiple temperature applications.

Typical Use

• As a mortar
• Spall repair/rebuilding of joint shoulders
• As a topping for delaminated slabs
• Fill in holes, gouges, ruts, popouts
• Repair broken slab panel corners